The VIP-Tow Brake allows for easy installation and operation: One bracket is bolted to the floor on your car and the other bracket is bolted to your brake pedal. The rest is just electrical wiring. All of the wiring is included with the kit to connect from the brake pedal on the car to the control in the motor home. The kit contains easy, step by step instructions for the HANDY-MAN MECHANIC.

No maintenance needed - no oiling; Permanent magnet motor - no brushes to replace; No filters to clog, no fittings to leak, no airlines to crack or deteriorate AND no air tanks to worry about moisture! This system is stable and worry-free; not affected by environment! It does not compromise your existing brake systems. No cutting brake lines or modifying the braking system, tow bar or hitch!

Easy to Remove to drive your car: Simply unplug the power, pull two pins and set the unit in the back seat or trunk. This takes less than one minute. The removable unit weighs just 14 lbs. It is cylindrically shaped; 2" in diameter and approximately 15" long.

Another Control Panel is also located in the towed vehicle: There is a green light on the box that verifies correct wiring. You can also test the unit from here before driving.

• No Hydraulic or Brake Invasion
• Does Not Void Warranties
• Thousands of Satisfied Customers
• Break-Away Standard and Integrated
• Hot Brake Warning
• Personal Tech Support for New Installing Dealers
• Driver Controlled with Audible and Visual Alarms

The VIP-TOW><BRAKE® is a non-invasive all-electric supplemental brake. Backed by an industry leading 10-year manufacturer's warranty

The VIP-Tow Brake mounts in the car between the floor board and the brake pedal and is electrically activated from the motor home. After working with surge brakes, proportional, air and hydraulic brakes, Tow Brake International took the best features of each without modifying your present braking system or hitch. Three custom adjustments allow you to drive and stop like you would if you were not towing!

Automatic Operation - Works instantly when you need to stop quickly!
Manual Operation - You can apply the brake without applying the motor home brakes for slippery surfaces or steep grades for complete control over the system! This feature is a lifesaver during a front tire "blow-out" on the motor home.
Break-Away Feature - The ONLY INTEGRATED (built in) system available. It automatically applies the brakes to the detached vehicle and they will remain applied until electrically released.

Custom Remote Control Operation from the Motor home: From the motor home driver's seat, you can see by the green status light that the system is operational - ready to go. Also, you can manually activate the Tow Brake at any time. It also allows you to temporarily defeat the automatic portion for severe conditions. Wired Operation - Immune to electrical interference!

DEALERS:
If you are Selling Tow Bars and Hitches, ask Your Customers If They Have Considered a Tow Brake

The VIP-TOW><BRAKE® Tote Bag is designed to hold the Tow><Brake unit for safekeeping when it is not in use. Inside this lightweight, canvas bag is an EZ Reference Guide that includes directions for connecting and disconnecting the Tow><Brake unit and protects your investment.

This kit is designed so that you can tow two different cars (at different times) using the same Tow Brake kit. This kit includes wiring, brackets, hardware, junction box, and instructions for wiring. Minor pressure adjustment to actuator is required.

This kit includes all of the towing vehicle wiring including the M1 control module, 50' or 6 wire cable, connector, battery and ground wires, junction box and instructions for wiring.